![]() The utility can create a Windows installation DVD from the ISO file as well. Microsoft’s Windows USB/DVD Download Tool takes an ISO image and creates a bootable USB device that can be used to install Windows on legacy (BIOS/MBR-based) systems. Option 3: Using Windows USB/DVD Download Tool That’s it! The USB drive is now bootable, and you should be able to install Windows from it. The bootsect.exe command-line builds the boot sector code in the specified partition. Successfully updated FAT32 filesystem bootcode.īootcode was successfully updated on all targeted volumes. You’ll see the following output: Target volumes will be updated with BOOTMGR compatible bootcode. Switch to the admin Command Prompt window and run the following commands, where H:\ is the drive letter of the mounted Windows ISO and G:\ is the USB drive letter: H:.Copy the entire contents of the mounted ISO drive ( H:\) to your USB flash drive ( G:\).Mount the Windows Setup ISO by double-clicking on it.Now, Windows reassigns a drive letter ( G:\ in this example) for your USB drive. Once done, run the assign command, and then type exit to come out of the Diskpart command environment.To format the partition as FAT32, type format fs=fat32 quick, and then click ENTER. Important note: If your computer supports Unified Extensible Firmware Interface (UEFI), you should format the USB flash drive as FAT32 rather than as NTFS. Then run the following commands: create partition primary.Then, run the following command to completely erase the contents of the USB disk: clean.In my case, disk 3 is the USB drive, so I type the following command to select the disk: select disk 3.It’s better to disconnect additional external drives before running this command, for easy identification of the USB drive. Carefully, note down the disk # for your USB media. Run the list disk command to see the list of drives.Open admin Command Prompt run the diskpart command.Insert the USB flash disk into the drive.This is sufficient to make the drive bootable in UEFI-based computers.įor legacy (BIOS/MBR) systems, follow these instructions to create a Windows 10 Setup USB disk. For UEFI-based computers, all you need to do to make a USB Windows setup disk is to format the USB drive as FAT32 (instead of NTFS), mount the Windows Setup ISO to a drive, and copy the entire contents of the mounted drive to the USB drive. Option 2: Create USB Setup Disk without using any softwareīefore you begin, note that you don’t need any software to create bootable USB media for UEFI-based computers. you need to flash a BIOS or other firmware from DOS.you need to work on a system that doesn’t have an OS installed.you need to create USB installation media from bootable ISOs (Windows, Linux, UEFI, etc.).Rufus is extremely fast, and this tool can be especially useful for cases where: Rufus – ISO to USB boot media creator.įor UEFI-based computers, choose GPT in the Partition scheme This utility helps format and create bootable USB flash drives, such as USB keys/pen drives, memory sticks, etc. Media Creation Tool can download ISO and create a USB setup disk (opens another article page) Create Bootable USB Flash Drive from ISO Option 1: Rufus: An Advanced Tool to Create Bootable USB DriveĪlso, look at an advanced ISO/DVD to USB tool named Rufus. ![]() Using the Windows USB/DVD Download Tool (Only for legacy BIOS/MBR-based systems).Using built-in Windows command-line - without 3rd party software.Using Rufus: An Advanced Tool to Create Bootable USB Drives (For both BIOS/UEFI systems).Create USB Bootable Windows Setup Disk from ISO:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |